EZFlora Irrigation Controller

More Views

INSTEON EZFlora Irrigation Controller

model EZFlora by Smartenit

protocols INSTEON

Be the first to review this product

EZFlora is an 8-zone irrigation unit capable of controlling valves either individually, or in program sequences in response to single INSTEON or X10 commands from a home automation control program like Indigo. Used in INSTEON mode means it has the normal INSTEON features of repeating powerline INSTEON signals which means that your INSTEON mesh network becomes a notch stronger. And, of course, like all INSTEON modules, it has 2-way communications for high reliability. EZFlora has a built-in power line interface and requires only a 24VAC irrigation transformer to power the valves.

Availability: In stock


Flexible Programming Options Your can program the EZFlora INSTEON/X10 8-Zone Sprinkler Controller to turn your sprinklers on and off at specific times at designated intervals. You have the ability to set up to four independent irrigation programs for different zones of your yard. One valve is even programmable for pump (always on) control, and separate timers are stored to prevent a valve being left on indefinitely. EZFlora can memorize up to 4 program sequences which can then be recalled via a single INSTEON or X10 command. Indigo, in tandem with the INSTEON PowerLinc Modem 2413U is required to use the EZFlora.) 

Indigo supports native INSTEON communication with the EZFlora. EZFlora users can specify unused zones by setting a \"0\" for that zone inside the maximum zone durations field. The EZFlora defaults to a maximum zone duration of 30 minutes. If this is not enough for your zones then you can change them and press the Set button. Indigo provides buttons in the main window, as well as action types that can be executed, for the following:

  • Advancing zones
  • Running a schedule of zone durations
  • Stopping the schedule
  • Pausing/resuming the schedule


Indigo must be running on your Mac for the EZFlora to be controlled. See these helpful Indigo hardware compatibility tables

X10 Setup

If you want to use the EZFlora in an X10 mode, then remember that it uses an entire House code and is shipped with X10 disabled. To enable or disable X10, push and hold the Set button for at least 10 seconds. The LED will blink at a low rate when the button is released. Now enter an ON (or OFF for disabling) command from your X10 controller. The LED will stop blinking indicating X10 enabling or disabling was successful. The new setting is stored in EZFlora's memory.


  • Dimensions (inches) : 4-5/16 x 2-3/8 x 1-3/8
  • Irrigation Zones: 8
  • Power Input: 120V AC, 100mA, 60Hz
  • Power Output: 24V AC, 400mA (each zone)
  • Warranty: 1 year, limited via the manufacturer

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.